Table of Contents
Advertisement
Adjusting the clutch
Adjusting the clutch must not be done while the engine is running.
The moving distance at the end of the clutch operation lever should be 10-
20mm. If needed, screw off the locking nut on the clutch operation cable
and adjust the clutch lever to stipulate the moving distance.
If large-scale adjustment is needed, turn the adjusting screw rod on the
right crankcase cover.
After adjustment, start engine, confirm clutch is working normally. if it is
skipping or is hard to put into gear than readjust.
Adjusting the brake pedal
When checking the disc brake system, hold the motorcycle upright with
the side stand.
1. The free moving distance of the rear brake pedal should be 15-25mm.
2. After making the adjustment, tighten the adjustment nut.
Caution
Braking lamp should light up after checking the brake system.
Kick Stand
This motorcycle only has a side stand.
27
10 - 20mm
1
2
1. Side stand
2. Rear armrest
2
1
1. Limit bolt
2. Rear brake pedal
Moto3 User Manual
Advertisement
Table of Contents
