Maintenance During Stops; Storage Maintenance - Braaap Moto3 User Manual

VIII: Maintenance During Stops

Storage maintenance

Prevent exposure to moisture and rain so as to avoid unnecessary damage due to long-term storage. Especially check the
important component parts of motorcycle before storing.
1. Replace the lubricant.
2. Lubricate the drive chain.
3. Empty the fuel oil in fuel tank and carburetor, close fuel cock, fill the fuel tank with anti rust liquid and cover fuel tank
cap. if the motorcycle is stored for over one month, the carburetor must be cleared completely of remaining fuel.
Caution
Fuel oil is combustible, therefore stop the engine on oiling and discharging, and do not smoke near oil storage or other
position in which the fuel oil is added.
NOTE
Screw the key to "OFF" position before pushing the start arm; in addition, install the spark plug on the cap and ground it to
prevent the ignition system from damage.
4. Remove the battery, keep it in a shady, cool and ventilated area and recharge the battery once a month.
5. Clean the motor cycle, coat the colored component parts with dye fixing agent, and paint the corrodible parts with rust
inhibiting oil.
6. Inflate the tires according to specified pressure and then raise the tires by placing wooden pads under them so that
they do not touch the ground.
7. Cover the motorcycle with the coat.
36
Moto3 User Manual