Engine Start-Up; Engine Run In - Braaap Moto3 User Manual

Engine Start-UP

1. Put key in ignition switch in the position of "
2. Put the emergency stop switch in the position of "
3. Confirm neutral position (make sure the neutral
indicator light is on).
4. Check the amount of fuel.
5. Turn the fuel valve cock to "Open"
Cold starting:
1. Raise up the choke lever on the carburetor (Tum off
choke valve).
2. Turn throttle 1/8,-1/4 of a turn.
3. Use electric or kick starting.
4. Slightly turn throttle lever, use rotational speed of
engine to warm the bike up.
5. when bike is warmed up, turn choke lever downward,
completely open the choke.
Caution
Make sure the engine is in neutral when starting otherwise
an accident may occur. When warming up the bike do not
rev the engine. Let it idle until it gets warm.
Warning
Do not start the engine in the room with poor ventilation or without ventilating device because carbon monoxide is very toxic.
Do not get off the motorcycle with the engine running if noone is around to guard it.
17
Engine stop
" 1. Loosen throttle lever to decrease the rotational speed of
" engine.
2. Put the bike into neutral.
3. Turn the ignition switch to "OFF"
4. Turn the fuel valve "OFF"
Engine run in period
For a new vehicle, the initial 1,000kms is the wear-in
period. In this period, the following items should be taken into
account:
1. Do not carry heavy goods and attempt to climb steep
slopes.
2. Do not exceed 50km.
3. Warm up the engine for 3-5min each time so as to
adequately lubricate the engine before each ride.
4. For the first 500kms do not go above 50kms an hour.
From 500-1000kms do not exceed 55kms
Moto3 User Manual