Table of Contents
Advertisement
The bottle under the coolant tank is purely an overflow and need NOT be
topped up.
Carburetor
The carburetor has been adjusted to the best working condition when leaving the
factory. Different climates may affect it.
(l) Start the engine and warm it up.
(2) After the engine has been warmed up you may need to turn the idle speed
adjustment screw to make the engine run stable at 1400 rpm. But we do not
recommend you play with this unless you know what you are doing.
Brakes and brake fluid
Check the brakes and brake fluid after the initial 1000km and then every
3000 km.
Spark plug
The spark plug gap between the two electrodes is 0.6-0.7mm. Replace the
spark every 8000km
The spark plug is D8EA
Battery
The Battery voltage should be at 12.5-12.8 V. (YTX7A)
Tire Pressure
Inadequate tire pressure will not only quicken the tire wear but also affect the
riding stability. Low pressure will make turning difficult. But too high PSI
may lead to skidding or even loss of control. The pressure must be kept
within the specified range. Pressure adjustment should be done when the tire
is cold. We recommend you check them weekly until you know the feel of
this bike flat tires can cause you to fall.
Front Wheel
32PSI
Rear Wheel
34PSI
- 30 -
Advertisement
Table of Contents
