Table of Contents
Advertisement
After Operation
After Operation Safety
After Operation General Safety
• Engage the parking brake (if applicable), shut off the machine, remove the key, and wait
for all movement to stop before adjusting, cleaning, or repairing the machine.
• Do not touch parts that may be hot from operation. Allow them to cool before attempting
to maintain, adjust, or service the machine.
• Clean debris from drives and the motor to help prevent fires.
• Use care when loading or unloading the machine onto a trailer or truck.
Battery and Charger Safety
• Confirm the voltage that is available in your country before using the charger.
• Do not get the charger wet; keep it protected from rain and snow.
• A risk of fire, electric shock, or injury may result from using an accessory not
recommended or sold by Toro.
• To reduce risk of a battery explosion, follow these instructions and the instructions for any
equipment that you intend to use near the charger.
• Batteries could emit explosive gasses if they are significantly overcharged.
• Refer to an Authorized Service Dealer to service or replace a battery.
• Never allow children or untrained people to operate or service the charger. Local
regulations may restrict the age of the operator. The owner is responsible for training all
operators and mechanics.
• Never allow children or untrained people to operate or service the charger. Local
regulations may restrict the age of the operator. The owner is responsible for training all
operators and mechanics.
• Keep bystanders and children away while charging.
• Wear appropriate clothing while charging, including eye protection; long pants; and
substantial, slip-resistant footwear.
• Shut off the machine and wait until the machine has completely powered down before
charging. Failure to do this may cause arcing.
• Ensure that the area is well ventilated while charging.
• The charger is for use on only nominal 120 to 240 VAC operation. For use with 240 V
circuits, contact your Authorized Service Dealer for the correct power cord.
• Do not charge a frozen battery.
• Do not abuse the cord. Do not yank on the power supply cord to disconnect the charger
from the receptacle. Keep the cord from heat, oil, and sharp edges.
• Connect the charger directly to a grounding receptacle. Do not use the charger on an
ungrounded outlet, even with a grounding adapter.
• Do not alter the provided power cord or plug.
Operation: After Operation
Page 4–7
3440-398 A
Advertisement
Table of Contents
