Table of Contents
Advertisement
Starting the Machine
1. Ensure that the battery-disconnect switch is in the ON position.
2. Stand on the platform.
3. Insert the key into the key switch and turn it to the ON position.
Note:
starting a cold machine, keep the machine above -7°C (20°F).
Shutting off the Machine
1. Park the machine on a level surface.
2. Put the drive controls in the
3. Turn the key switch to the O
Operator Platform
You can use the machine with the platform in the up or down position.
The operator platform is heavy and may cause injury when you raise or lower it.
Carefully lower or raise the operator platform, as suddenly dropping it could injure
you.
• Do not put your hands or fingers in the platform-pivot area when lowering or
raising the operator platform.
• Make sure that the platform is supported when you pull the latch pin out.
• Make sure that the latch secures the platform when folding it up. Push it tight
against the cushion for the latch pin to lock into place.
• Keep bystanders away from the machine when raising or lowering the platform.
Operate the machine with the platform up for the following conditions:
• Using the machine near drop-offs
• Using the machine in small areas where the machine is too large
• Areas with low-hanging branches or obstacles
• When loading or unloading the machine from a trailer for transport
• Driving up slopes
Operate the machine with the platform down for the following conditions:
• Using the machine in most areas
• Driving across slopes
• Driving down slopes
3440-398A
The machine may have difficulty starting under severe cold conditions. When
position.
NEUTRAL
position and remove the key.
FF
WARNING
Page 4–4
Operation: During Operation
Advertisement
Table of Contents
