Dumping The Material; After Operation; After Operation Safety; Cleaning The Drum - Toro MMX-658H-S Operator's Manual

7. Allow the paddles to mix the material until the
ingredients have a uniform appearance.
Note:
If needed, add water or plaster, cement,
or other binding material until the consistency
of the batch is correct.

Dumping the Material

DANGER
Contact with the mixing paddles could cause
damage or injury.
Never put your hands inside the drum while
the engine is running.
Note:
When dumping a batch of material, leave
the engine/motor running and the clutch in the O
position so that the rotating paddles help discharge
the material.
1. Align a wheelbarrow or similar container of
adequate capacity in the path of the drum
opening.
2. Grasp the dump handle with your left hand
(Figure 31).
1. Dump handle—Mix
position
2. Drum latch—Release
position
3. Lift the handle of the drum latch
Figure 31
3. Drum latch—Locked
position
4. Dump handle—Dump
position
(Figure
4. With both hands on the dump handle, rotate it
counterclockwise to discharge the contents of
the drum
Note:
discharge the contents of the drum.
5. Rotate the dump handle clockwise until the
drum latch locks the drum in the upright position
(Figure
6. After dumping a batch of material, clean
the drum to prevent dried material from
contaminating the next batch of material; refer to
Cleaning the Drum (page

After Operation

N

After Operation Safety

General Safety
•
Park the machine on a level surface, shut off the
engine, wait for all moving parts to stop, and allow
the machine to cool before adjusting, cleaning,
storing, or repairing the machine.
•
Chock the tires of the machine or keep it attached
to the towing vehicle when it is not in use.
•
Do not touch parts that may be hot from operation.
Allow them to cool before attempting to maintain,
adjust, or service the machine.

Cleaning the Drum

Important:
shovel, hammer, or any other device to loosen any
accumulated dried materials.
1. Move the clutch lever to the O
the paddles.
2. Shut off the engine/motor.
3. Ensure that the drum is in the mix position
(upright).
4. Spray the machine with water to remove any
accumulated material.
5. Start the engine/motor.
g028574
6. Move the clutch lever to the O
the paddles.
7. Dump the drum.
31).
23
(Figure 31).
Allow the machine to completely
31).
23).
Do not strike on the drum with a
position to stop
FF
position to start
N