Chamber Or Manifold Requirements; Space Requirements; Your Next Step - Labconco FreeZone Plus Manual

Hide thumbs Also See for FreeZone Plus:

Table of Contents

Chapter 2: Prerequisites

Vacuum pumps used with 115V models should be

equipped with a 115V, 15 Amp NEMA 5-15P plug.

Vacuum pumps used with 230V models should be

equipped with a "reverse" IEC 320 plug. This will

allow the vacuum pump to be plugged into the

receptacle on the back of the Freeze Dryer. See

Appendix D: Freeze Dryer Accessories for vacuum

pumps available from Labconco.

Chamber or Manifold

Requirements

A freeze drying chamber or manifold must be

purchased separately. These allow samples to be

attached to the Freeze Dryer. See Appendix D: Freeze

Dryer Accessories for available chambers and

manifolds.

Refer to Appendix C: Freeze Dryer Specifications for

dimensional drawings of the Freeze Dryer.

After you have determined that the location for your

Freeze Dryer accommodates the installation and

operational requirements, you are ready to unpack and

install your Freeze Dryer. Proceed to Chapter 3:

Getting Started.

Product Service: Domestic 1-800-522-7658, International 816-333-8811

Table of Contents

Need help?

Do you have a question about the FreeZone Plus and is the answer not in the manual?