YASKAWA 1000 Series Installation Manual page 22

5 Installation Procedure
7.
Route the option wiring.
Depending on the drive model, some drives may require routing the wiring through
the side of the front cover to the outside. In these cases, cut out the perforated
openings on the left side of the drive front cover as shown in
no sharp edges to damage wiring.
Route the wiring inside the enclosure as shown in
require routing through the front cover.
Refer to the Peripheral Devices & Options section of the drive instruction manual for
more information.
Figure 8
A – Route wires through the openings
provided on the left side of the
front cover.
<1> The drive will not meet NEMA Type 1 requirements if wiring is exposed outside the enclosure.
22
A
<1>
Figure 9 Wire Routing Examples
YASKAWA ELECTRIC TOBP C730600 37C 1000-Series Option PG-X3 Installation Manual
Figure
Figure 9-B for drives that do not
B – Use the open space provided
inside the drive to route option
wiring.
9-A and leave
B