Replacing Light - Viking VEDO5302SS Use & Care Manual

Cleaning and Maintenance
To start the Self-Clean cycle:
1. Close the door completely.
2. Turn the oven selector knob clockwise to the self-clean mode.
3. Turn the temperature control knob past the clean setting until the knob stops. At this time, the clean indicator light will
come on. Within 30 seconds the automatic door latch engages and the oven indicator light comes on. The oven indicator
light will remain on until the oven reaches the self-clean temperature and will then cycle on and off during the self-clean
cycle.
4. The "clean" indicator light will remain on until the self-clean is completed or interrupted and the oven temperature drops to
a safe temperature. A complete cycle approximately 3 1/2 hours with an additional 30 minutes needed for the oven to cool
down enough for the door latch to disengage. NOTE: A fan noise will be heard during the self-clean cycle and will continue
to run for the 3 1/2 hour duration of the self-clean cycle.
5. When the cycle is completed, turn both the oven selector and temperature control knob to the off position. When the oven
has completely cooled, open door and remove any ash from the oven surfaces with a damp cloth.
To stop the Self-Clean cycle:
To cancel or interrupt the self-cleaning cycle, turn both the temperature control knob and the oven function selector knob to
OFF. When the oven temperature drops to a safe temperature, the automatic door latch will release and the oven door can be
opened. When the oven has completely cooled, remove any ash from the oven surfaces with a damp sponge or cloth.
Replacing Interior Halogen Oven Lights
Do not touch bulb with bare hands. Clean off any signs of oil from the bulb and handle
with a soft cloth.
1. Unsnap glass light cover using a screwdriver in the access groove.
2. Firmly grasp light bulb and pull out.
3. Replace with halogen bulb using volt and wattage requirements listed
on glass cover.
4. Replace the light cover by snapping glass cover onto metal box.
5. Reconnect power at the main fuse or circuit breaker.
Power Failure
Do not attempt to use during a power failure. Unit will not function.
CAUTION
DISCONNECT THE ELECTRIC POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BEFORE REPLACING BULB.
access
groove
light
bulb
28
glass light
cover