All Traffic Solutions SpeedAlert 18 Quick Start Manual

SpeedAlert 18 Quick Start Guide
Thank you for purchasing an All Traffic Solutions SpeedAlert 18 Radar Speed Sign. This
Quick Start Guide will show you how to set up, power, and configure your new sign. If you
have a TraffiCloud subscription, you can log on to TraffiCloud to set up your signs remotely.
Non-subscribers can complete sign setup locally. See Step 4: Configure the SpeedAlert 18
locally on the next page.
[Figure 1] SpeedAlert 18
Radar Speed Sign

Step 2: Charge the batteries

The SpeedAlert 18 arrives with the batteries partially charged and needs to be fully charged before deployment.
RISK OF ELECTRIC SHOCK AND DAMAGE TO EQUIPMENT The charger is not intended for
W :
ARNING
outdoor use. Only charge and store the batteries in a controlled environment.
A. Plug the battery into the supplied charger cable.
B. Plug the charger cable into a power outlet. The light on the charger displays red while charging and changes to
green when charging is nearly complete. A charge can take up to 11 hours for the 12V 16Ah LFP batteries
supplied with the sign.
C. When the indicator on the battery charger turns green, repeat for the second battery if applicable, and then
proceed to the next step.
ATS | Chantilly, VA | United States | Tel: 1-866-366-6602 | Email:
Copyright © 2022 | All Traffic Solutions, Inc.® | Document ver.1.01 | All rights reserved.

Step 1: Unpack the equipment

Remove the sign, batteries, charger, and other optional equipment from the boxes.
Batteries should be fully charged before deployment. SpeedAlert Radar Message Signs
can accommodate up to two 16Ah lithium batteries internally. Although only one battery
is required, two batteries are recommended to extend the run time of the sign, on
average from 7 to 10 days.
For all steps involving batteries, repeat for the second battery as necessary.
To remove the batteries:
A. Place the SpeedAlert 18 face down on a flat surface and remove the mounting
bracket by unlocking the lock with the supplied key and lifting up on the bottom of
the mounting bracket.
B. Next, remove the battery compartment cover by removing the thumb screws. Set
the key, bracket, and thumb screws aside.
C. Slide the battery out of the battery compartment, as shown in [Figure 2] below.
D. Disconnect the connectors, as shown in [Figure 3] below.
[Figure 2] Slide the battery [Figure 3] Disconnect/connect
sales@alltrafficsolutions.com | Web: www.alltrafficsolutions.com