Setting Up As A Post-Processing Base - Leica Viva GNSS Getting Started Manual

1.2
Use
Description



Viva GNSS, Equipment

Setting up as a Post-Processing Base

The equipment setups described following are to be used for static operations over
markers.
The instrument can be programmed with the CS field controller before use which can
then be omitted from the setup.
• GNSS antenna/GS15 instrument is mounted directly using screw fitting. If using
stub and adapter, procedures can vary slightly.
• When using the adapter and carrier, ensure that the GNSS antenna and the
adapter assembly slide down the full length of the carrier stub. An incorrectly
mounted GNSS antenna will have a direct effect on the results.
• GNSS antennas are AS05 or AS10. Procedures/setup can vary if AR25/AT504GG
is used.
If the instrument is left in the container during use in high temperatures, the lid
should be left open. Refer to the GS10/GS15 User Manual for operating and storage
temperatures.
Use an external battery such as GEB171 to ensure operation for a full day.
11