Advertisement
10. Charging Instructions
Use the charging unit provided in the package to charge the battery to ensure that the battery has sufficient power.
Insert the battery into the corresponding battery slot to start charging the battery. (You can also use a USB 6Pin
charging cable to charge the battery through the controller)
Supplementary Instructions
1. The motor comes standard with 0.8M gear,Special circumstances require gears (0.4m, 0.5m, 0.6m), you can contact the
after-sales service or buy them at the PDMOVIE official website.
2. Any problems with the motor during calibration,Just click the motor button once to terminate the calibration.
3. When controlling the SLR lens, it is recommended to adjust the rotation speed of the motor to medium speed or slow speed
for better effect.
4. The calibration of the SLR lens is recommended to use the manual method of calibrating the lens.
5. The normal working voltage of the motor is between 7 and 20V, Use D-tap power cable (applicable to common V-mount
special batteries for film and television), if you need to use other power cable, please ensure that other power have 7 ～ 20V
output power supply, the current reach more than 3A.
6. The normal working time of the controller PD4-HT is 12 hours，If the battery is low while working，It can be used with mobile
power sources such as USB 5V output.It can be fully charged after 60 minutes of normal charging.（The controller 6-pin socket
supports 5V-18V voltage input, please use it with confidence.）
7. When the motor working stroke suddenly does not match the original calibration travel,check whether the indicator light of the
controller PD4-HT flashes alternately between the current channel color and white，Flashing alternately indicates that the
current control channel has set the travel limit of point A-B，Short press the corresponding control part button to cancel the
point A-B.
8. Powerful motor PD-RP, it is recommended to use a professional camera lithium battery above 150Wh for power supply, the
best effect.If the battery output voltage is not enough, the motor speed can be adjusted to medium or low speed.
9. About battery maintenance: When not in use for a long time, it is recommended to check the battery power every other month
to ensure that the battery has sufficient power; when the battery is in a low or no power state for a long time, the battery capacity
will become smaller; Excessive discharge will cause damage to the battery. If the battery is swollen or damaged, please
purchase a new battery for replacement and promptly discard the old battery.
Align position
10
Assembled successfully
Status Indicator
Red light is always on when charging
Green light is always on when
charging is complete
Advertisement
