Advertisement
Instruction Manual
1. Install the Motor
Install the motor on the 19mm or 15mm conduit (requires an adapter ring), pay attention to clamp the
motor gear and lens gear, then lock the U clip, and finally install the antenna and power cable or
serial cable on the receiver motor (PD-RP).
1.Install the motor
on (15/19mm) rods
2. Wiring
PD4-S1 Single Channel ：Connect the power cable to the PD-RP (receiver motor) and the battery
with the D/P-tap socket.
PD4-S2(Double
Channel)：First connect PD-RP and PD-MX (slave motor) with serial cable, then
connect PD-MX and battery (with D/P-tap socket) with power cable.
PD4-S3 Three Channel
and two PD-MX, and finally use power cable to connect PD-MX and battery (with D/P-tap socket)
*
The REMOTE 7-20V sockets on the PD-RP and PD-MX have the same function are used for power and
signal transmission.
2.Locking U-clamp
：First use two serial cables to complete the connection between PD-RP
Serial Cable
PD-RP
(Receiver Motor
Slave Motor
Install
Serial Cable
PD-MX
PD-MX
Slave Motor
5
3.Install the Antenna
and the Power Cable
D-Tap Power Cable
Advertisement
