Advertisement
*When the controller and the motor are in the same signal channel and control channel, and the lens is
automatically calibrated, it can be used.
7. Adjust the speed
Before using the focus of the controller to control the handwheel and the push-pull Lever on both sides, please check
whether the motors in the corresponding control channels can be used normally. Short press the ZOOM/IRIS button of
the controller 5 times to cycle through the three-speed control speed of the ZOOM/IRIS push-pull rod (FOCUS cannot
adjust the speed, the default is the fastest). Short press the button at the bottom of the motor 5 times to switch the
motor speed cyclically. In addition, the rotational speed and direction of the motor can be adjusted by the controller or
the motor.
BUTTON
ON/OFF
③
Start/stop recording：This function requires additional purchase of video cables of different models of cameras to use.
⑨
Change the speed：This function only supports adjusting the two push-pull rod parts of ZOOM and IRIS.Because the Focus
handwheel defaults to the fastest speed, it cannot be changed
Blinking Fast = Fast Speed
Blinking Slow = Medium Speed
Always On = Slow Speed
(Short press the button for 5 cycles to adjust)
*More features，See the table below
NUMBER OF BUTTON PRESSES
①
Long press 3 seconds
②
Short press 1 time
③
Short press 2 times
④
Short press 3 times and long press 3 seconds
⑤
Long press 3 seconds
⑥
Short press 1 time
⑦
Short press 2 times
⑧
Short press 3 times
⑨
Short press 5 times
⑩
Short press 7 times
Controller button manual
FUNCTION
TURN ON/OFF
CHANGE CHANNEL
START/STOP RECORDING
BLUETOOTH PAIRING
CALIBRATION THE LENS
A - B POINT LIMIT
CHANGE CONTROL CHANNEL
ZOOM
IRIS CONTROL CHANNEL EXCHANGE
CHANGE THE ZOOM / IRIS SPEED
CHANGE THE MOTOR DIRECTION
8
Blinking Fast = Fast Speed
Blinking Slow = Medium Speed
Always On = Slow Speed
(Short press the button for 5 cycles to adjust)
The default is the fastest, the
indicator light is always on
（Not adjustable）
Blinking Fast = Fast Speed
Blinking Slow = Medium Speed
Always On = Slow Speed
(Short press the button for 5 cycles to adjust)
Advertisement
