Advertisement
BUTTON
①
Short press 1 time
②
Short press 2 times
③
Short press 3 times
④
Short press 4 times
⑤
Short press 5 times
⑥
Long press 3 seconds
⑦
Short press 7 times
①Change signal channel/stop calibration：Only the receiver motor needs to switch the signal channel, and the slave motor does not.In case
of emergency during the automatic calibration of the motor, you can short press the button once to terminate the automatic calibration.
④Clear calibrated lens stroke：When the motor has calibrated the lens stroke, Short press the button four times, will clear calibrated lens
stroke；
Power outage recovery stroke：Power off when the motor change battery during use，Short press the button 4 times after the motor
restarting，The last calibrated the lens stroke can be restored.（This function does not apply if the motor installation position is changed）
⑤The indicator light flashes quickly：Motor speed is fast；The indicator light flashes slowly：The motor speed is medium ；The indicator
light is always on：The motor speed is slow.
8. Download and connect the APP
The controller supports Bluetooth connection to IOS APP, Mark lens data through APP, Motor direct control or linkage
control.Open the APP Store, search for PDMOVIE or REMOTE AIR in the Apple Store to download.Currently only IOS
systems are supported.
1.Turn on the
phone's
bluetooth and
start the APP
10.Long press the AUTO box
or use the original way to
calibrate the lens travel,Try
using step 8 or 9 to control
the motor
*APP Control Interface, FOCUS channel corresponds to the red indicator，IRIS channel corresponds to blue indicator
，ZOOM channel corresponds to green indicator，Please check if the indicator light of the controller component is
the same color as the corresponding above. Step 3 After starting the controller，can first adjust the color of the
controller's FOCUS/IRIS/ZOOM indicator to red/blue/green.
Log in to PDMOVIE official website to get REMOTE AIR APP usage tutorial. The HELP item of the SET interface in
the APP also has a complete introduction to APP functions.
9. Marking Disk
After aligning the notch of the marking disk with the buckle on the handle, slide the marking ring into the conttroller firmly.
2.Click to enter
the Bluetooth
3.Start the
selection
controller
interface
9.Click the FOCUS
channel,Make the subject box
black（Disabled）,Turn the
controller handwheel and
observe whether the control bar
follows the change
FUNCTION
CHANGE SIGNAL CHANNEL/STOP CALIBRATION
CHANGE CONTROL CHANNEL
CHANGE ALTERNATE CHANNEL
RESET/RECOVERY CALIBRATION（POWER OUTAGE）
CHANGE MOTOR SPEED FAST/MEDIUM/SLOW
CALIBRAE THE LENS
CHANGE MOTOR DIRECTION
5.Select product
4.Choose the
category as REMOTE
Bluetooth and
AIR PRO，Then click
rename it
Connect
8.Slide each channel
strip,Check if the value of
FZI in the OLED screen of
the controller changes
accordingly
9
Motor button manual
REMOTE AIR APP
6.Click
CONTINUE
enter the main
interface of the
APP
Click
7.
the "-" icon in
the FOCUS channel,
selected controller
bluetooth
Additional Accessories
to
Advertisement
