PDMOVIE REMOTE AIR PRO 3 Product Manual page 8

Controller button
Short press 2 times
Instruction Manuals
6. Calibrate the lens
Method 1: Press and hold any of the FOCUS, ZOOM and IRIS buttons on the controller for three seconds, the
motor will will automatically calibrate the lens travel. When using multiple channels, multiple motors will start
auto-calibration at the same time.
Method 2: Press and hold the the motor button for three seconds until the motor turns and release, the motor
will automatically calibrate the lens. When using multiple channels, it is necessary to operate motor by motor.
Press for
Method 3: Manually calibrate the lens travel: After the motor powers on, make sure that the motor gear and
the lens gear are fully engaged, manually rotate the lens to the starting point and stop for 0.5 seconds, then
rotate the lens to the end point and stop for 0.5 seconds, and finally, turn the lens slightly towards the starting
point, the motor will complete the lens travel learning. (Lenses without hard stops are best for this feature)
When using multiple channels, it is necessary to operate motor by motor.
Motor button
Short press 2 times
Short press 3 times
Set Up
FOCUS
IRIS
3S
Channel Indicator color
R1
G2 GREEN
B3
Y4
C5
P6
Press any of the
three buttons for 3
seconds
7
RED
BLUE
Yellow Alternate channel
Cyan Alternate channel
Purple Alternate channel
ZOOM
Control
FOCUS
ZOOM
IRIS