Table of Contents
Advertisement
(3) Manually calibration:
A. When the motor gear and the lens gear are completely connected,turn
the lens to the starting point and hold for 0.5 seconds.
B. Then turn the lens ring to the end and hold for 0.5 seconds.
C. Finally, turn the lens ring slightly to the middle, Calibrate done.(It is
recommend that you use manual calibration when using a DSLR
camera lens)
(1) Turn the lens ring to
the starting point and
hold for 0.5 seconds.
5. Charging instructions
-
The controller is plugged into the charging cable, and the controller battery
is charged via usb 5v. (See the picture below-1)
- The motor battery charge 1 charge 4 charging device, through the usb 5v
to charge the motor battery. (See the picture below-2)
Indicator light
·Lights For Charger Status
·During charging, the light is
purple.
·When the charging is finished,
the light is white.
·Lights For Charger Status
·During charging, the light is red.
·When the charging is finished,
The color of the
indicator light
WHITE
GREEN
YELLOW
RED
(2) Turn the lens ring to the
end and hold for 0.5
seconds, then turn the lens
ring slightly toward the
center.
the light is green.
Residual electricity
100% - 75%
75% - 50%
50% - 25%
25% - 0%
Advertisement
Table of Contents
