Ember Bed Led Replacement - Dimplex WINSLOW SWM3520 Service Manual

EMBER BED LED REPLACEMENT

1. Follow the steps 1-4 of "Preparing for Service" on page 4 of this manual before continuing.
2. Remove the logs, rocks, or glass chunks and set them aside.
3. Remove the two screws that secure the media tray, and remove it. (Image 10)
4. Remove the screw that secure the LED strips to the firebox, as well as the post. If there is too
much resistance removing the post by hand, a 3/16" wrench can be used. (Image 10)
5. Peel off the silicone on the connector(s), and unplug the connection(s).
! Note: The silicone is only necessary during transportation of the product, and does not need to
be replaced.
6. Plug in the connector(s), and secure the new board using the screw(s) and post(s) previously
removed.
7. Re-install the media tray and put back the logs, rocks, or glass chunks.
8. Re-install the fireplace as it was before.
9. Sit back and enjoy!
10
Required
10