Table of Contents
Advertisement
Operation
Configuration (Standalone)
Set the product in the standalone mode to control without a DMX controller.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX signals
that could interfere with the DMX signals from the controller.
Static Color Mode
To run the COLORband PiX ILS on a static color, follow the instructions below.
1. Press <MENU> repeatedly until C-- shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select a static color, from C 1–7.
4. Press <ENTER>.
Automatic Program
To run a program on the COLORband PiX ILS, follow the instructions below.
1. Press <MENU> repeatedly until P-- shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select an automatic program, from P 1–23.
4. Press <ENTER>.
Auto Program Speed
To adjust the auto program speed on the COLORband PiX ILS, do the following:
1. Press <MENU> repeatedly until S-- shows on the display.
2. Use <UP> or <DOWN> to increase or decrease the program speed, from S. 1–100.
3. Press <ENTER>.
Sound-Active Programs
To run the COLORband PiX ILS with a sound-active program, follow the instructions below.
1. Press <MENU> repeatedly until Snd shows on the display.
2. Press <ENTER>.
Sound Sensitivity
To set the sound sensitivity on the COLORband PiX ILS, do the following:
1.
Press <MENU> repeatedly until SenS shows on the display.
2.
Use <UP> or <DOWN> to increase or decrease the sound sensitivity, from u 0–100.
Press <ENTER>.
Custom Color Mixing
To mix a custom color on the COLORband PiX ILS, do the following:
1. Press <MENU> repeatedly until u-- shows on the display.
2. Press <ENTER> and one of the following will show on the display:
•
r. _ _ _ (red)
•
G. _ _ _ (green)
•
b. _ _ _ (blue)
3. Press <ENTER> to cycle through the options.
4. Use <UP> or <DOWN> to increase or decrease the selected value, from 0–255.
5. Repeat steps 3 and 4 until the color is set as desired.
Dimmer
To set the dimmer speed/value on the COLORband PiX ILS, follow the instructions below.
1. Press <MENU> repeatedly until dIM shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to set the dimmer, from dIM1 (fast) to dIM3 (slow) or oFF.
4. Press <ENTER>.
COLORband PiX ILS User Manual Rev. 1
Page 15 of 21
Advertisement
Table of Contents
