Ups-Removing And Replacing - IBM NetVista Kiosk DBCS Hardware Service Manual

UPS–removing and replacing
Follow these steps to remove or replace the UPS:
26
1. Power off the NetVista Kiosk. See "Powering off the NetVista Kiosk" on page 4.
Make sure that the 4835, printer, scanner, power distribution switch, and the
UPS are powered off.
2. Unplug the power cord from the external ac power source going to the Kiosk
enclosure.
3. Remove the four screws J and the eject paper tray K . See the illustration
on page 27.
4. Detach the three UPS power cord cable retainers A , B , and C .
5. Release the UPS RS-232 interface cable from the cable clamps D .
D
D
A
A
B
B
C
C