ZyXEL Communications OLT2406 User Manual page 303

Figure 184 Advanced Application > ONT Template
The following table describes the labels in this screen.
Table 131 Advanced Application > ONT Template
LABEL DESCRIPTION
Choose the GPON interface that you want the settings configured here to apply to from the
drop-down list.
Configure the ONT registration settings and select the ONT Template Active checkbox for a GPON
interface in the OLT Registration screen. You'll have GPON interfaces to choose from the drop-
down list.
ONT AID Select a template from the table below by clicking a hyperlink in the AID field.
Note: It's required to put a value in this field.
Active Select this to enable the ONT template.
Note: It's required to enable or disable the ONT template in this field.
Template Enter a description to aid in identifying the template.
Description
Alarm Profile Select the alarm profile this template uses. Click Alarm Profile Setting to configure or edit an alarm
profile.
Full Bridge Select the Enable checkbox to have the ONT allow the traffic of all the four UNI (User Network
Interface) ports once any one of them is configured.
Anti MAC Select the Enable checkbox to activate anti-MAC spoofing for the ONT.
Spoofing
Loop Guard Select the check box to enable the loop guard feature on the ONT. Otherwise, clear the check
box.
Specify the time interval (from 1 to 60 seconds) that the OLT waits before shutting down a port in
a loop state. The registered ONT connected to the shut-down port will remain registered.
You can also leave this field empty, and the OLT will shut down a port in a loop state immediately.
You can go to the Advanced Application > Errdisable > Errdisable Recovery screen to configure
the time interval at which the OLT enables the shut-down port automatically when it's no longer in
a loop state.
If error-disable recovery is not enabled, you can go to the Basic Setting > Port Setup screen to
enable the shut-down port.
OLT2406 User's Guide
303