Table of Contents
Advertisement
Figure 270 MVR Multicast Television Example
76.8 General MVR Configuration
Use the mvr <vid> command to create multicast VLANs and select the receiver port(s) and a source
port for each multicast VLAN. Use the show mvr command to display the settings.
Note: You can create up to five multicast VLANs and up to 256 multicast rules on the OLT.
Note: Your OLT automatically creates a static VLAN (with the same VID) when you create a
multicast VLAN.
OLT2406# show mvr
Behavior: IGMP Snooping
Multicast Vlan Registration Status
MVLAN: 10
Name
------------ ------------------------------- ------------------------------
The following table describes the MVR commands.
Table 279 General MVR Configuration Commands
COMMAND
show mvr
show mvr <vlan-id>
mvr behavior <0|1>
mvr <vlan-id>
8021p-priority <0-7>
group <name-str>
inactive
mode <dynamic|compatible>
Chapter 76 Multicast
Active: Yes
Mode: Dynamic
msc-1-1, msc-1-2
OLT2406 User's Guide
545
802.1p Priority: 0
Source Port Receiver Port
ge-5-1
DESCRIPTION
Shows the MVR status.
Shows the detailed MVR status and MVR group
configuration for a VLAN.
: 1 ~ 4094
vlan-id
Selects MVR behavior on the OLT. Choices are 0
for IGMP Snooping and 1 for IGMP Proxy.
Enters config-mvr mode for the specified VLAN
ID (1 to 4094). Creates the MVR, if necessary.
Sets the IEEE 802.1p priority of outgoing MVR
packets.
Sets the MVR multicast group name.
name-str: 1-32 English keyboard characters
Disables the MVR settings.
Sets the MVR mode (dynamic or compatible).
E
3
E
3
C
13
C
13
C
13
C
13
C
13
C
13
Advertisement
Table of Contents
Troubleshooting
