Advertisement
2. BEHIND SEAT FILLER (black rubber)
2.1 Note: adhesive-backed velcro should be applied to a
clean, dry surface at room temperature. Tip the seat up if
it's not already. Lay out the rubber filler as would seem
appropriate then apply the self-adhesive hook velcro
where needed (i.e.: vehicle fenders, etc.). See figures 2.1
and 2.1.1. Note: fig. 2.1.1 shows a soft side rear curtain
in place. The seat belt storage brackets should fit into the
clearance slits provided in the rubber. Adhere the behind
seat filler to the newly installed velcro strips.
3. REAR LEGS
If installing a soft sided cab,
3.1 Install the rear leg oriented as shown in fig. 3.1
(with the gussets facing the front and the weatherseal
towards the outside of the vehicle). Re-install the 2 origi-
nal equipment bolts, but do not tighten. Repeat for oppo-
site side.
behind the seat filler
(black rubber piece)
Fig. 2.1 Behind seat filler
velcro here
Fig. 2.1.1 View from left side
gussets
Fig. 3.1 View from left side of vehicle
p. 4 of 16
apply velcro
here too
weatherseal
Advertisement
