Advertisement
4. SIDE FRAMES
4.1 With assistance, temporarily remove the doors from
the side frames (for easier handling) by unlatching and
sliding up and off the pin hinges.
4.2 Attach one contour to the inside edge of each side
frame using five self-drilling screws. See fig. 4.2. Note:
extra screws are provided in case one gets lost. Be sure to
select the appropriate contour for the specific tractor
model number. The wider pair is for the 2320. The nar-
row pair is for the 2520/2720. Place the intentional iden-
tification notch towards the rear of the side frame (see
figure 4.3). Start by using the 1/8" shy of flush approach
to the outer radius of the bent tubing and adjust only
where necessary to guarantee at least a minimum of 1/4"
overhang on the inside radius so there will be sufficient
room to accept the bulb rubber to be installed next. Re-
peat for opposite side.
4.3 Install the bulb rubber to the sheet metal contour
pieces as shown in fig. 4.3.
4.4 For 2320 only, place the supplied 5/8" thick spacer
over the hole in the floorboard of the vehicle where the
original equipment bolt was removed in step 1.6. Repeat
for opposite side.
a min. of a 1/4"
overhang is de-
sirable the entire
inside length
Ref.: leave approximately
1/8" of space instead of being
exactly flush with the tube
Fig. 4.2 Attaching Contour pieces
Ref.: identification
notch to be here
Fig. 4.3 Installing bulb rubber
place the supplied
5/8" thick spacer here
Fig. 4.4 View of right side
p. 6 of 16
install self-
drilling screws
bulb rubber
Advertisement
