Advertisement
15. WIPER (electric)
15.1 Install the wiper motor per the instructions includ-
ed with the kit.
16. PLASTIC NUT COVERS
16.1 Install the 5/16" plastic nut covers on all the interi-
or locknuts.
17. FINISHING TOUCHES
17.1 Note: extra hardware has been provided in case
some gets lost. Discard extras such as washers and lock-
nuts, etc.
17.2 At the owner's discretion, the two grab handles
removed in step 1.2 can either be discarded or re-
installed in reverse orientation. See fig. 17.2.
Care and Maintenance Instructions
Check and tighten hardware after 40 hours of operation.
Periodically inspect and tighten hardware for the remain-
der of the unit's life.
Wash the painted surfaces of the unit with commercial
automotive cleaning products.
Clean windows with glass cleaner.
Vinyl components should be washed with a mild solu-
tion of warm soapy water.
Clear vinyl can be easily scratched. Be careful cleaning
frost or snow from windows. Do not roll curtains in cold
weather. The windows become stiff and may crack.
Keep windows clean.
CABS/BLADES/ SPREADERS/ACCESSORIES
originally the grab handle
was facing outboard
Fig. 17.2 Grab handle (left side)
(viewed from the front)
p. 13 of 16
Advertisement
