Advertisement
p. 12 of 16
14. DOORS
14.1 Apply grease to the pin hinges if desired. With as-
sistance, re-install the doors onto the pin hinges. See fig-
ure 14.1. Work the doors back and forth until the hinges
are completely seated. Note: the hinges, inside latch, and
striker bolt can also be adjusted for proper engagement.
14.2 For hard sided doors only, install the gas shock to
the frame and door with the small piston end towards the
door. Press the button on the compression fastener to
lock the gas shock to the ball stud.
14.3 For soft sided doors only, install the vinyl coated
cable door stop to the welded tabs on the door and side
frame. See fig. 14.3. Use the following hardware: four
5/16-18 x 3/4" long hex head bolts, eight steel washers,
and four locknuts. Do not tighten down firmly. Allow for
Fig. 14.1 Hard sided door shown
free pivoting.
Fig. 14.3 Soft Side door stop
Advertisement
