Advertisement
1. FIRST THINGS FIRST
1.1 Refer to the parts lists on pages 16, 17, and 18 and
segregate which components you will and will not need
for your particular make and model tractor.
For 2320: Keep:
wider pair of contours
top filler
Discard: narrow pair of contours
front leg bottom
cowl insert
For 2520 and 2720: Keep: narrow contours
Discard: top filler
1.2 Remove the two grab handles shown in fig. 1.2. At
the owner's discretion, these handles can be discarded or
re-installed in reverse orientation once the cab installa-
tion is complete.
1.3 For models 2520/2720 only, remove and discard
the floorboard extensions as shown in fig. 1.3. Save 4 of
the 6 bolts, flat washers, and split washers for re-use in
step 6.1.
1.4 Adjust the orientation of the two seat belt brackets if
they are not set at approximately 45 degrees already. See
fig. 1.4. Two-fold reasoning: 1) for clearance for hard
sided rear panel to sit properly, 2) the clearance slits in
the Behind Seat Filler (black rubber piece) are predeter-
mined to be approximately 45 degrees. To adjust the ori-
entation, simply put a wrench on the head of the bolt and
turn the entire bolted assembly a few degrees. No need to
loosen the locknut underneath the fender.
1.5 Remove and save for re-use the front four (2/side)
original equipment bolts from the base of the ROPS
structure as shown in figure 1.5. Note: the vehicle has
factory installed inserts (no loose locknuts or washers).
1.6 For model 2320 only, remove the floorboard bolt
closest to the rear fender on each side and discard. See
figure 1.6.
remove
this bolt
Fig. 1.6 View of right side
front leg bottom
cowl insert
wider contours
Fig. 1.2 Handles removed
Fig. 1.3 On 2520/2720 only, remove extensions
seat belt storage bracket
Fig. 1.4 View from left side of vehicle
ROPS bolts
Fig. 1.5 View from left side of vehicle
p. 3 of 16
Advertisement
