Voice Recording; Troubleshooting - Akai Party Box 810 User Manual

VOICE RECORDING

This unit and 'capable of recording the vocals on the USB memory or SD card when using the
supplied microphone. The device will automatically create a folder called "Record" inside the
USB memory and it will store all log files.
1. Switch On the unit;
2. Insert a USB memory or a SD Card into the socket;
3. Select the USB or SD function
the remote control;
4. Via the REC (06) button on the unit or REC button (03) on remote control to start recording,
the display will show "REC" and the time signature will start;
5. Press again REC button to stop recording. The unit will play, automatically, the recorded file.
Note:
- You can record only the voice.
- When the "Recording" function is activated, some appliance controls are inhibited, they will
resume their normal function when the recording is stopped.

TROUBLESHOOTING

If a problem occurs, follow the steps in the table below.
If the problem still can't be solved, please contact your retailer.
Problem
No sound when
power is turned ON
Distorted sound
No sound from the
microphone
No sound comes after
inserting USB/SD Card
Charging indication-red
light flashing when there
is low charge
Unable to charge or the
battery works only for
short duration
If Speaker makes
loud noises
MODE button (02) on the unit, or the
Possible cause
1. No input sound source comes
2. Volume knob in the lowest position
3. Voice switch off
4. USB/SD card not plugged
1. Volume is too loud
2. Audio file error
1. Microphone socket may not be
plugged properly.
2. Microphone switch may not be on.
3. Microphone volume is on lowest mode.
1. Incorrect file format
2. USB/SD may not be plugged properly
Charging adapter is not inserted properly. It will not affect the speaker system.
1. Connect with power cord to charge
2. Battery not fully charged
3. Battery life may have ended
1. Microphone switched on but may too
close to the speaker
2. Microphone switched on but is not
being used
3. Microphone volume may be too loud
4. Mobile phone is being used too close
to the speaker
5. Other wireless equipment may be
placed very close to the speaker
Solution
1. Input AUX signal
2. Adjust volume
3. Turn on voice switch
4. Plug USB/SD card, play MP3
1. Turn the volume down
2. Check and change the audio file
1. Ensure the microphone is correctly
plugged into the socket.
2. Turn on the microphone
3. Adjust the microphone volume as per
users wish
1. File format should be MP3
2. Plug USB/SD card correctly
The light is only used for indicating
whether the unit is charging
1. Check if power cord connected properly
2. Extend charging time; normally it takes
6-8 hour to fully charge
3. Replace old batteries with the same
specification as the old batteries.
1. Keep the microphone 2 meters away
from the speaker
2. Turn off microphone if not in use.
3. Adjust microphone volume to lower
mode
4. Keep mobile away from the speaker
whilst a ending a call.
5. Keep the speaker away from other
wireless equipment
button (04) on