Table of Contents
Advertisement
What to do if the descaling procedure is interrupted
Error codes
6
6 Make sure that the HygieSteam container is correctly assembled and attached
to the machine. Place the milk tube in the milk tube holder.
7
7 Follow the instructions on the screen to start the descaling procedure. The
descaling procedure lasts approx. 30 minutes and consists of a descaling cycle
and a rinsing cycle.
8 Once the descaling cycle is finished, you need to rinse the water tank and
8
water circuit. Follow the instructions on the screen.
9
9 Place a new AquaClean filter in the water tank and activate it (see
the AquaClean water filter (5
Tip: Using the AquaClean filter reduces the need for descaling!
You can exit the descaling procedure by pressing the on/off icon on the control
panel. If the descaling procedure is interrupted before it is completely finished,
some descaling liquid may remain in the water tank or the water circuit. In that
case, do the following:
1
1 Empty and rinse the water tank thoroughly.
2 Fill the water tank with fresh water up to the CALC CLEAN level indication
2
and switch the machine back on. The machine will heat up and perform an
automatic rinsing cycle.
3 Before brewing any drinks, perform a manual rinsing cycle. To perform a
3
manual rinsing cycle, first dispense half a water tank of hot water and then
brew 2 cups of pre-ground coffee without adding ground coffee.
Note: If the descaling procedure was not completed, the machine will require
another descaling procedure as soon as possible.
Below you find a list of the error codes showing problems that you can solve
yourself. Video instructions are available on
error code appears, please contact the Consumer Care Center in your country.
For contact details, see the warranty leaflet.
min.)).
www.saeco.com/care
25
Activating
. If another
Advertisement
Table of Contents
