2.4 Wiring the Power Inputs
The 6-contact terminal block connector on the top panel of Industrial PoE+
Switch is used for two DC redundant power inputs. Please follow the steps
below to insert the power wire.
When performing any of the procedures like inserting the wires
or tightening the wire-clamp screws, make sure the power is
OFF to prevent from getting an electric shock.
1. Insert positive and negative DC power wires into Contacts 1 and 2 for
Power 1, or Contacts 5 and 6 for Power 2.
2. Tighten the wire-clamp screws for preventing the wires from loosening.
8
Max. Fault Alarm Loading: 24V, 1A
1 2 3 4 5 6
1
2
3
4
Power 1
Alarm
+
-
DC Input:
48-54V
, 7A max.
5
6
Power 2
+
-