Important To Installer; Removing The Shipping Bolts; Installing The Washing Machine; Selecting A Location - Maytag MAH2400A Installation Instructions Manual

IMPORTANT TO INSTALLER

Please Read The Following Instructions Carefully Before Installing The
Washing Machine.
These Instructions Should Be Retained For Future Reference.
Remove The Door From All Discarded Appliances To Avoid The Danger Of
A Child Suffocating.
STEP 1
PREPARE WASHER

Removing The Shipping Bolts

Before using the washing machine, you must remove the five shipping bolts
from the back of the unit.
1. Loosen all bolts with the supplied wrench before
removing them.
2. Slide the bolt and spacer up and remove the bolt
with spacer through the hole in the rear wall of the
washer. Repeat for each bolt.
3. Fill the holes with the supplied plastic covers.
4.
Keep the shipping bolts and spacers for future use.
STEP 2

INSTALLING THE WASHING MACHINE

Selecting a location

Before you install the washing machine, select a location with the following characteristics:
• A hard, level surface (if the surface is uneven, see "Adjusting the leveling feet,"
below)
• Locate away from direct sunlight.
• Adequate ventilation
• Room temperature that will not fall below 0 °C
Room temperature that will not fall below 32°F or 0°C.
• Away from sources of heat such as coal or gas
• Make sure that the washing machine does not stand on its power cord.
• Carpeting must not obstruct ventilation openings when the washing machine is
installed on a carpeted floor.
6