Initial Switch And Jumper Settings; Check Point Block - NEC IE-789835-NS-EM1 User Manual

2.2 Initial Switch and Jumper Settings

The initial switch and jumper settings of the IE-789835-NS-EM1 are shown in Table 2-1.
For the setting of JP2, refer to 3.4 Clock Settings.
For the settings of SW1 to SW6, refer to 3.6 LCD Emulation.
Initial setting
Initial setting

2.3 Check Point Block

The through holes of the check point block (refer to Figure 2-1 IE-789835-NS-EM1 Part Names) are provided at
intervals of 2.54 mm (1 inch) both vertically and horizontally, allowing confirmation of the signal of each port pin
inside the IE-789835-NS-EM1.
P00, P01, P02, P03, P04, P05, P06, P07
P10, P11, P60, P61, P62, N.C, N.C, N.C
P20, P21, P22, P23, P24, P25, P26, P27
Caution Do not connect or capture the signal inside the IE system, or the IE system may be damaged.
Remark The through holes indicated by
CHAPTER 2 PART NAMES
Table 2-1. Initial Switch and Jumper Settings
SW1 SW2
OFF ICE side ICE side
Figure 2-2. Check Point Block
Signals inside IE system
(N.C.) are not connected to any signal.
User's Manual U16290EJ1V0UM
JP2
2 and 3 shorted
SW3 SW4
ICE side ICE side
P30, P31, P32, P33, P34, P35, P36, P37
P80, P81, P82, P83, P84, P85, P86, P87
Signals inside IE system
Signals inside IE system
Signals inside IE system
SW5 SW6
ICE side
17