Table of Contents
Advertisement
<2> Prepare the IE-789835-NS-EM1.
<3> Remove the crystal oscillator that is mounted in the IE-789835-NS-EM1's socket (the socket marked
as X1).
<4> Connect the parts board (from <1> above) to the socket (X1) from which the crystal oscillator was
removed. Check the pin 1 mark to make sure the board is mounted in the correct direction.
<5> Make sure that the parts board is wired as shown in Figure 3-11.
<6> Install the IE-789835-NS-EM1 in the IE-78K0S-NS or IE-78K0S-NS-A.
The above steps configure the following circuit and enable supply of the clock from the mounted resonator
to the emulation device.
28
CHAPTER 3
INSTALLATION
User's Manual U16290EJ1V0UM
Advertisement
Table of Contents
