Plan Vent System - Maytag Epic MGDZ600T Use And Care Manual

Choose your exhaust installation type
Recommended exhaust installations
Typical installations vent the dryer from the rear of the dryer. Other installations are possible.
A
A. Dryer E. Clamps
B. Elbow F. Rigid metal or exible metal vent
C. Wall G. Vent length necessary to connect elbows
D. Exhaust hood H. Exhaust outlet
Optional exhaust installations
WARNING
Cover unused exhaust holes with one of the
following kits:
279818 (white)
W10186596 (midnight grey)
Contact your local dealer.
Failure to follow these instructions can result in death,
fire, electrical shock, or serious injury.
12
B
C
D
E
F
G
H
Fire Hazard

Plan Vent System

This dryer can be converted to exhaust out the right side, left side, or through the bottom.
Contact your local dealer to have the dryer converted.
A
Alternate installations for close clearances
Venting systems come in many varieties. Select the type best for your installation. Two close-
clearance installations are shown. Refer to the manufacturer's instructions.
NOTE: The following kits for close clearance alternate installations are available for purchase.
Please see the "Assistance or Service" section to order.
Over-the-Top Installation:
Part Number 4396028
Periscope Installation (For use with dryer vent to wall vent mismatch):
Part Number 4396037 - 0" (0 cm) to 18" (45.72 cm) mismatch
Part Number 4396011 - 18" (45.72 cm) to 29" (73.66 cm) mismatch
Part Number 4396014 - 29" (73.66 cm) to 50" (127 cm) mismatch
B
A. Standard rear offset exhaust installation
B. Left or right side exhaust installation
C. Bottom exhaust installation (not an option with
pedestal installations)
A B
A. Over-the-top installation (also available with one
offset elbow)
B. Periscope installation
C