Commissioning And Operation (Software); Switch The Reader On/Off; Energy States / Power Modes - Siemens SIMATIC RF660M Operating Instructions Manual

Mobile reader
Hide thumbs Also See for SIMATIC RF660M:
Table of Contents

Advertisement

4.2

Commissioning and operation (software)

4.2.1

Switch the reader on/off

Using the On/Off button on the right of the mobile reader, you can switch the reader on/off
or restart it.
Switching on
To switch the mobile reader on, press the On/Off button on the right of the reader ( ).
As soon as the mobile reader has been switched on, the status LED of the reader lights up
green and the home screen of the operating system or your usual work environment appears
on the display.
Switching off/restarting
To switch the mobile reader off, hold down the On/Off button on the right of the reader for
three seconds ( ).
After the three seconds, a dialog will appear on the right of the display with the options
"Switch off", "Restart" and "Screenshot". Press the "Switch off" button to switch off the reader.
Alternatively, you can of course also restart the reader using the corresponding button.
The status LED goes off as soon as the mobile reader is switched off.
If you do not want to perform any of the three options, you can close the dialog by pressing
on a free area of the display.
4.2.2

Energy states / power modes

The mobile reader has a power-saving mode and an emergency power supply.
Idle mode (power saving mode)
To activate Idle mode of the mobile reader, hold down the On/Off button on the right of the
reader for two seconds ( ).
In Idle mode, (system) processes minimize their power consumption and only the necessary
system components are kept running in order to save energy. In addition, the display is
switched off so that the reader uses only very little power and the battery lifetime can be
extended.
From this mode, the reader can be set to operational mode again very quickly because the
operating system does not need to be rebooted. Note that the reader continues to be
supplied with power in Idle mode and this mode can therefore only be retained for a certain
amount of time (depending on the charge level of the reader battery).
To switch back to operational mode, press the On/Off button on he right of the reader again
( ).
Mobile reader SIMATIC RF660M
Operating Instructions, 02/2022, C79000-G8976-C660-01
4.2 Commissioning and operation (software)
Commissioning
27

Advertisement

Table of Contents
loading

This manual is also suitable for:

Simatic rf360rSimatic rf160bSimatic rf660h

Table of Contents