Commissioning; Commissioning (Hardware); Connecting The Charging/Docking Station - Siemens SIMATIC RF660M Operating Instructions Manual

Commissioning

4.1

Commissioning (hardware)

Before the first commissioning of the mobile reader, make sure that the battery inserted in
the reader in the factory is fully charged. You can charge the battery by placing the reader in
the charging/docking station. To do this, connect the charging/docking station to the power
supply using the power supply unit provided and insert the reader in the charging/docking
station.
4.1.1

Connecting the charging/docking station

You can charge the battery of the mobile reader and spare batteries using the
charging/docking station. Over the Ethernet interface, you can connect the charging/docking
station with your network via a reader. Over the USB interface, you can connect removable
data storage media to the charging/docking station.
Procedure
Follow these steps to connect and commission the charging/docking station:
1. Set up the charging/docking station in a level, stable, clean place, away from direct sunlight.
2. Insert the power supply cable into the external power supply unit.
3. Insert the DC plug of the power supply unit into the DC socket on the rear of the
charging/docking station (
4. If necessary, insert the Ethernet cable into the RJ45 socket on the rear of the
charging/docking station.
Mobile reader SIMATIC RF660M
Operating Instructions, 02/2022, C79000-G8976-C660-01
).
4
17