Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for VolantexRC Sport Cub S2
Summary of Contents for VolantexRC Sport Cub S2
- Page 1 Gyro Stabilizer System...
- Page 2 2 / 8...
- Page 3 Charging 1. Connect the Li-Po battery to the CAUTION: Do not store the Li-Po battery included USB charger. in the charger. Doing so could over-discharge 2. Connect the USB charger to a phone the Li-Po battery. USB charge adapter (not included) or into any powered USB port.
-
Page 4: Installing The Flight Battery
Transmitter A: Throttle B: Dual Rate C: Antenna D: Speaker E: LED F: Steering G: Steering Trim H: Power Switch Installing the Flight Battery 1. Make sure the throttle is in the off position and turn on the transmitter. 2. Open the battery hatch on the bottom of the airplane and plug in the flight battery. 3. -
Page 5: Flight Control
Flight Control CAUTION: Keep away from the propellers, they will spin up during the control test. Arm the motors by below steps. 1. Turn the airplane on as shown above. 2. Turn the transmitter on. 3. Arm the motors by first moving the left stick to 100% and then back down to 0%. - Page 6 Direction of Drift Bend to Correct 1. Center the transmitter trims. 2. Carefully bend the control surface in the direction shown in the chart to the left. NOTE: Only make small adjustments to the control surfaces. Avoid making large changes as this could affect flight performance.
-
Page 7: Flying Conditions
Fly in spacious ground without obstacles and boskage. area and residential area. outdoors only. Flying Conditions Also, if you are a first-time or low-time pilot, we highly recommend that allow a more After you have properly trimmed the airplane in calm conditions and become familiar experience and comfort level, in winds up to 5-7 mph.
Need help?
Do you have a question about the Sport Cub S2 and is the answer not in the manual?
Questions and answers