Atag KU8574K2C Instructions For Use Manual page 44

Reversing the door opening direction
44
13. Tighten the screws. The screws should
be tightened to a torque of 6.2 Nm.
14. Close the door and make sure it is
aligned with the housing. The housing
side and the edge of the door should be
parallel.
15. If the door is not aligned with the housing
(the angle α is not 0°),
then proceed as follows:
1. Open the door and detach the gasket
from its groove in the corners at the top
and bottom hinge.