Lock Settings; Alarms - Atag KU8574K2C Instructions For Use Manual

Key lock mode deactivation:
•
with a 3 seconds press on Key lock key
• manually from mobile application.

Lock settings

This is a ConnectLife app function that gives extended lock settings options to appliance key lock.
Default status in ConnectLife app is "Not active". These lock settings can only be used when appliance
key lock is activated, manually or automatically (from settings menu or from the same ConnectLife
app). If appliance key lock is turned on, this will not turn on any lock settings. On the other hand, if
Key lock is deactivated, all extended lock settings will be disabled.
Lock settings consists of two functions: door notification and door alarm. They can be enabled
separately so one can be on and the other one off, or both on.
Door notification
Door notification is a notification message you will get in your smart device when the door is open.
Door alarm
Door alarm is an alarm sound that plays when the door opens, to hear when appliance is being used.
To stop this alarm, close the door or press key lock key for 3 seconds to turn key lock off. Remember
that turning key lock off disables all lock settings, so, to enable again door alarm it can only be done
in the ConnectLife app.
In case of a Power failure, lock settings remain active when power returns to the appliance.

Alarms

Please refer also to chapter "Tips & Tricks" to learn more about possible reasons for each particular
alarm.
All alarms will be displayed using the alarm pop-up.
Temperature alarm
The temperature alarm will go off when the temperature in the appliance compartment is out of range
for more than 3 hours.
When this happens, an alarm will sound, compartment temperature will blink and a pop-up will show
up on the screen.
INFORMATION!
Every time the appliance is switched on again, it takes a while until the correct temperature is
reached. For this reason, the alarm is disabled for the first 6 hours after the appliance is switched
on to prevent the unnecessary activation of the alarm. Each time the door is closed, temperature
alarm is blocked for 3 hours.
If the difference between old setpoint and new setpoint is:
• less than 5°C, it has no influence on temperature alarm,
• between 5 and 10°C, temperature alarm is blocked for 24h,
• higher than 10°C, temperature alarm is blocked for 80h.
,
Operation
29