Table of Contents
Advertisement
X Internal I/O Connectors
SATA (Serial ATA)
The Serial ATA (SATA) connectors are used to connect the Serial ATA device. SATA 3.0 is sup-
ported by the five SATA ports and provides data rate up to 6Gb/s. Connect one end of the Se-
rial ATA cable to a SATA connector and the other end to your Serial ATA device.
BIOS Setting
Configure the Serial ATA drives in the Chipset menu ("PCH-IO Configuration" > "SATA And RST
Configuration") of the BIOS. Refer to the chapter 3 for more information.
Features
•
4 x Serial ATA 3.0 internal ports, two of which support disk on module (DOM)
•
SATA 3.0 data transfer rate up to 6Gb/s
•
Integrated Advanced Host Controller Interface (AHCI) controller
•
Intel
Smart Response Technology
®
•
RAID 0, RAID 1, RAID 5, RAID 10
User's Manual | CS636
„ SATA Pin Assignment
1
GND
TX+
G1: 5V (DOM only)
TX-
GND
G2: GND (DOM only)
RX-
RX+
GND
7
SATA3 SATA 3.0 DOM supported
SATA2 SATA 3.0 DOM supported
SATA 3.0 Double Stack Connector:
SATA 1 (bottom)
SATA 0 (top)
Internal I/O Connectors
X
Digital I/O
The 8-bit Digital I/O (DIO) connector allows for input/output signals of digital logical states de-
fined by voltage levels.
Jumper Setting
Digital I/O power supply can be configured via jumper settings as instructed in
sections.
„ Digital I/O Pin Assignment
Pin
Function
1
DIO0
3
DIO2
5
DIO4
7
DIO6
9
GND
Chapter 2
HARDWARE INSTALLATION
9
1
10
2
„ Digital I/O
the previous
Pin
Function
2
DIO1
4
DIO3
6
DIO5
8
DIO7
10
5V/5VDU
22
Advertisement
Table of Contents
