Operating Instructions; Master 200 Solid State Control With; Electromechanical Timer; In Off Mode - Garland MCO-GS-10S Installation, Operation And Maintenance Manual

OPERATING INSTRUCTIONS

Master 200 Solid State Control With

Electromechanical Timer

In Off Mode

When the oven is off, there are no lights or indicators.

Start Up

Press the Cook/Off/Cool Down rocker switch to the "Cook" position.
The green lamp will light indicating the oven is powered in cook
mode.
The oven will begin to heat to the temperature set on the thermostat
dial. The amber lamp will light indicating the heat is active. As the
heat cycles on and off to maintain the set temperature this light will
go on and off accordingly.
The door must be closed for the oven to operate in cook mode.
Opening the door will cause the heat to stop. The motor and fan will
shut off. This is a safety feature.

Fan Speed

The fan speed can be either high (1670 RPM) or low (1430 RPM). The
fan speed is controlled by the left rocker switch marked high and low.

Lights

The oven lights are activated by pressing the light switch on the
control panel. This is a momentary switch and the lights will stay
lit as long as this button is held in the on position. Lights will work
whenever there is electrical power connected to the oven.

Cool Down

Pressing the Cook/Off/Cool Down rocker switch to the Cool Down
position activates the fan and motor to cool the oven cavity. The door
must be open slightly for the fan and motor to start. The heat is not
active in this mode.
Optimal cool down will be achieved with the door open slightly.
Opening the door too far will shut the fan and motor off. This is a
patented safety feature.
Pressing the button to the OFF position cancels the cool down and
turns the oven off.

Temperature

The temperature range is from 150°F to 500°F (66°C to 260°C) is
controlled by rotating the temperature dial and aligning the
indicator to the desired temperature.

Timer

The timer is set by rotating the dial clockwise aligning the indicator to
the desired time cycle. The timer will count down from 2 minutes to
60 minutes. At the end of the timing cycle the buzzer will sound. The
buzzer is turned off by rotating the dial counter clockwise to the off
position,
NOTE: The timer does not control heating
Document # G_GO_OM_CONVENTION_4607458 – 06/21 11