Operating The Controls; Cook-N-Hold Operation; Settings Mode; Cleaning Mode - Garland MCO-GS-10S Installation, Operation And Maintenance Manual

OPERATING INSTRUCTIONS Continued

Operating the Controls

Setting the cook temperature (from 150 deg. F to 500 deg.
F (65 deg. C to 260 deg. C)) and time are done in the same
manner (see photos 5 and 6).
When the timing cycle is started the display will count down
from the Set time in minutes and seconds. Note that an
alarm will sound when the set point temperature is reached
and the cook time is completed.

Cook-N-Hold Operation

Pressing the Cook-N-Hold symbol (see photo 4 -
thermometer symbol next to light bulb) activates the Cook-
N-Hold mode The display will show the hold temperature in
red. At the end of the cook cycle, an audible alarm will sound
and the display will change to count "up" the time the oven
is on hold. The oven will switch to the programmed hold
temperature. The timer will sound the alarm again after the
hold time has elapsed.
Setting the cook temperature, hold temperature and time
are done in the same manner (see photos 5 and 6). The
desired temperature is shown on the display.
Pressing the enter symbol will start the timing cycle.
Settings Mode (Gear Wheel)
-To enter the Settings screen a password must be keyed in
from the key pad (see photo 9). The Settings Mode allows
one to (see photo 10):
-Select deg. F or deg. C
-Select ECO Mode Temperature
-Select Cook & Hold Temperature
-Select Alarm Volume
-Perform software updates via USB (accessibility to
technicians only)
14
Photo 9
CLEANING MODE (Hand & Cloth - photo 11)
-In the cleaning mode the screen remains frozen for seven
seconds to allow for cleaning between operators
(see photo 12)
Photo 11
Document # G_GO_OM_CONVENTION_4607458 – 06/21
Photo 10
Photo 12