Options And Peripheral Equipment - A&D BM-5 Instruction Manual

Options and Peripheral Equipment

20.2.
Ethernet Interface
The interface to connect the balance to a LAN.
Accessory: "WinCT-Plus" data communication software.
The software can acquire data from multiple balances
connected to a LAN.
The software can control these balances with commands.
The software can acquire data transmitted from balances.
Example: When pressing the
data is output and is acquired by the computer.
The stored data can be used with Microsoft EXCEL (if
installed).
Pipette Accuracy Tester
Note This option cannot be used for the BM-5
and BM-5D.
This option can be used to inspect the volume
dispensed from the pipette.
The accessory evaporation trap is used to prevent
the evaporation of the test liquid inside it.
The WinCT-Pipette software converts the test liquid
mass into a volumetric value.
Electrode Unit of the Ionizer
Use these electrode units for replacement parts of the
ionizer built into the balance.
Replace all four units with new ones at the same time.
Refer to "6.5. Ionizer " for the replacement.
Display Cover
This option is the same as the accessory display cover.
Micro Tube Holder
This option is used when weighing with the general
micro tube or test tube under Φ 12 mm.
Note When using the micro tube holder for the
BM-5 and BM-5D:
The micro tube holder is approximately 2 g
heavier than the standard pan (weighing
pan and pan support). When a micro tube
holder is used for the BM-5 and BM-5D, the
available weighing range will be up to
approximately 3 g including the tare such
as a micro tube and test tube.
BM-08
PRINT
BM-014
AX-BM-NEEDLESET
AX-BM-031 (5 pieces)
AX-BM-032 (for the BM-5/5D/20/22, standard accessory)
AX-BM-034 (for the BM-252/200/300/500)
key of the balance,
Micro tube holder
104
5 mL, 30 mL
Sample cup
(4 pieces)
Micro tube
Test tube
BM series