Supermicro SuperServer 5019S-WR User Manual page 22

SuperServer 5019S-WR User's Manual
Power LED/Speaker
Pins 1-3 of the JD1 header are used for power LED indication and pins 4-7 are for the speaker.
Please note that the speaker connector pins (4-7) are for an external speaker. If you wish to
use the onboard speaker, you should close pins 6-7 with a jumper.
PWR LED Connector
Pin Definitions
Pin Setting Definition
1 DC 3.3V
2 FP_PWR_LED
3 FP_PWR_LED
Chassis Intrusion
A Chassis Intrusion header is located at JL1 on the motherboard. Attach the appropriate cable
from the chassis to inform you of a chassis intrusion when the chassis is opened.
Chassis Intrusion
Pin Definitions
Pin# Definition
1 Intrusion Input
2 Ground
TPM/Port 80 Header
A Trusted Platform Module (TPM)/Port 80 header is located at JTPM1 to provide TPM support
and a Port 80 connection. Use this header to enhance system performance and data security.
Trusted Platform Module Header
Pin Definitions
Pin# Definition
1 LCLK
3 LFRAME#
5 LRESET#
7 LAD3
9 +3.3V
11 LAD0
13 SMB_CLK
15 +3V Stdby
17 GND
19 LPCPD#
40
Speaker Connector
Pin Definitions
Pin Setting Definition
4 P5V
5 Key
6 R_SPKPIN_N
7 R_SPKPIN
Pin# Definition
2 GND
4 <(KEY)>
6 +5V
8 LAD2
10 LAD1
12 GND
14 SMB_DAT
16 SERIRQ
18 CLKRUN#
20 LDRQ#
Standby Power
The +5V Standby Power header is designated JSTBY1. You must have a card with a Standby
Power connector and a cable to use this feature.
Wake-On-LAN
Pin Definitions
Pin# Definition
1 +5V Standby
2 Ground
3 NC
SGPIO Headers
Two SGPIO (Serial General Purpose Input/Output) headers are available to communicate with
the enclosure management chip on the backplane. They support the onboard I-SATA 3.0 ports.
I-SGPIO 1/2
Support
I-SGPIO1 I-SATA 3.0 Ports 2-3
I-SGPIO2 I-SATA 3.0 Ports 4-7
Disk-On-Module Power Connector
Two power connectors for SATA DOM (Disk On Module) devices are located at JSD1 and
JSD2. Connect appropriate cables here to provide power support for your SATA DOM devices.
DOM Power
Pin Definitions
Pin# Definition
1 5V
2 Ground
3 Ground
4-pin BMC External I 2 C Header
A System Management Bus header for IPMI 2.0 is located at JIPMB1. Connect the appropriate
cable here to use the IPMB I C connection on your system.
2
External I C Header
2
Pin Definitions
Pin# Definition
1 Data
2 GND
3 Clock
4 NC
41
Chapter 4: Motherboard Connections
SGPIO Header
Pin Definitions
Pin# Definition Pin# Definition
1 NC 2 NC
3 Ground 4 DATA Out
5 Load 6 Ground
7 Clock 8 NC
NC = No Connection