Install A Processor - Lenovo ThinkSystem SR645 V3 User Manual

Step 1. Use a Torx T20 screwdriver to loosen the captive screw.
Step 2. Slightly lift up the retention frame in the direction shown.
Step 3. Slightly lift up the rail frame in the direction shown. The processor in the rail frame is spring-loaded.
Step 4. Hold the blue tab of the processor carrier and slide the processor carrier out of the rail frame.
After you finish
• If you are going to install a new processor, see
• If you are not going to install a processor, cover the processor socket with the socket cover and install a
processor filler.
Figure 72. Installing a processor filler
1. Gently open the retaining clip on each end of the memory module slots next to the left and right sides
of the processor.
2. Align the processor filler with the slots, and place the processor filler on the slots with both hands.
Firmly press the processor filler straight down into the slots until the retaining clips snap into the
locked position.
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.

Install a processor

Use this information to install a processor. This task requires a Torx T20 screwdriver. The procedure must be
executed by a trained technician.
About this task
Important: This task must be operated by trained technicians that are certified by Lenovo Service. Do no
attempt to remove or install it without proper training and qualification.
Attention:
"Install a processor" on page
.
Chapter 5
111.
Hardware replacement procedures
111