Editing A User-Entered Or Factory Calibration Curve - Hach POCKET COLORIMETER II Instruction Manual

User-Entered Calibration,
10. When all the calibration data has been entered, press
the measurement mode.

Editing a User-entered or Factory Calibration Curve

1. Press the
MENU
by "CAL". Press
2. Press the
READ/ENTER
"S0" will appear in the display.
Note: When editing a factory-calibrated meter or range, RES (resolution) cannot be changed.
Note: When RES or S0 appears in the display, press
data to be edited.
3. In uncalibrated meters or in Abs range, "RES" will appear. Press
to review the current resolution. Press
displayed resolution. To change the resolution (decimal placement), press
. Press
READ/ENTER
READ/ENTER
4. Press
READ/ENTER
display.
key and hold it down until the display shows "USER", followed
ZERO/SCROLL
key to enter Edit mode. In factory-calibrated meters,
ZERO/SCROLL
to accept. "S0" will appear on the display.
. The current concentration value for S0 will appear on the
continued
until EDIT appears.
ZERO/SCROLL
ZERO/SCROLL
to select the new resolution, then press
2—22
twice to return to
MENU
to quickly scroll to the
ZERO/SCROLL
again to accept the