Reviewing And Editing User-Entered Programs - Hach DR/820 Instrument Manual

SECTION 4,
continued

4.5 Reviewing and Editing User-Entered Programs

Note: When a user-
entered program is edited
and stored, all stored data
associated with that
program is erased.
20. Press the key once.
EXIT
21. Press the
ENTER
instrument's memory.
All method information previously stored by the operator can be
reviewed and changed to add, delete, or modify data points. At
any point during the editing function, the operator can terminate
the procedure and exit by pressing the
program will occur.
Because the standards must be read in the order of increasing
absorbancy, data points may not be inserted into the middle of an
existing user-entered program.
To review and edit previously stored user-entered programs:
1. Press the key to turn the instrument on.
I/O
2. Press the
SETUP
3. Scroll to the
USER
4. Enter the program number of the method to review or edit
and press the
ENTER
5. Scroll through the calibration information using the
keys. To avoid making changes, press the
6. To edit the data shown on the display, press
necessary changes, then press the
reviewing the data.
7. Press once.
EXIT
8. Press
to store the program.
ENTER
36
will be displayed.
STORE ?
key to store the new method in the
EXIT
key.
option and press
ENTER
key.
ENTER
will be displayed.
STORE?
key. No changes to the
.
ARROW
key.
EXIT
. Make
ENTER
key to return to