Water Cooling System; Rudder Service; Propeller Service - ProBoat IMPULSE 32 Instruction Manual

EN

Water Cooling System

If water does not stream out of the water outlets while the
boat is moving forward, immediately stop the boat and clean
the obstruction from the water cooling system.
There are two separate water circuits in the Impulse 32. The
Water rudder pickup cools the motor. A pickup on the bottom
of the boat cools the ESC.
1. Disassemble and clean the water cooling system to
remove blockage and prevent overheating.
2. Replace damaged parts.

Rudder Service

1. Disconnect the water tube from the rudder.
2. Remove the nut, screw and linkage from the rudder
arm.
3. Turn the rudder and loosen the set screw from the
rudder pin.
4. Turn over the boat and lightly tap the rudder to remove
the pin.
5. Assemble in reverse order.

Propeller Service

1. Use an 8mm nut driver (DYN2805) to loosen the nut from the
driveshaft.
2. Remove the nut and propeller from the driveshaft.
3. Assemble in reverse order. Correctly align the propeller with
the drive dog on the driveshaft.
10
Impulse 32-Inch Brushless 6S Deep V