Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for B2 Audio Zero.5
Summary of Contents for B2 Audio Zero.5
- Page 1 MODEL: Zero.5 Product id:ZERO.5D13 Zero.5 OWNER’S MANUAL...
-
Page 2: Table Of Contents
Introduction We thank you for purchasing our amplifiers. Your decision to be part of something different is what we strive for. Our products reflects who we are, going to the extent to deliver you our finest comes natural. Our amplifiers are engineered to accomondate a variety of applications. Whether it is SPL or SQ, the sound provided will be clean &... -
Page 3: Design Features
4000 W x 1 Description of Specifications Stable impedance load of the Zero.5 is 1 Ohm. Operation below minimum impedance will stress the amplifier & void the warranty. Excessive heat will also appear at a faster rate and the and the amplifier will go into thermal protection. -
Page 4: Panel Layout
Panel layout Zero.5 BASS BASS BOOST FREQ 0dB 9dB 30Hz 80Hz MASTER SLAVE1 SLAVE2 SWEET LIKE DANISH INPUT BASS BOOST Signal input from the head unit. A minimum level Variable bass boost with 0-9dB. input of 0.2V is essential for correct operation BASS FREQ POWER &... - Page 5 Panel layout Zero.5 + 12V (POWER CONNECTION) REM (REMOTE) Connects to the positive terminal of the battery (+12V). Connect to switched +12V from the headunit. For specified performance 0 GA cable is required. Fuses shall be placed within 20 cm / 8” of the battery.
-
Page 6: Installation
Connect the power cables to the power terminal labeled as +12V. The Zero.5 is not equipped with fuses and has to be fused both at the amplifier’s end and at the battery. Connect one end of the fuse holder to the power cable and the other end of the fuse holder to the positive battery terminal within 20 cm / 8’’... -
Page 7: Wiring Layout
Wiring layout +12V, GND, REM connection chart Head unit Zero.5 Remote turn on Keep GROUND of equal length. This drawing is for illustration purposes only! 200A (External fuses) We recommend using 12 AWG speaker cables to obtain intended performance. Run 12 AWG speaker cables from your speakers to the amplifier’s mounting location Keep the speaker cables seperate from the power cables and and the amplifier’s input cables. -
Page 8: Speaker Connection
SLAVE2 SWEET LIKE DANISH Daisy chain connection allows linking of 2 Zero.5 amplifiers to work as 1 single amplifier. Please read the following connection diagram cautiosly to ensure the correct connection. Step 1. Connect the master amplifier to the head unit and set its output master and input slave switch to output master position. -
Page 9: Troubleshooting
Troubleshooting The protection circuits of the amplifier prevents severe damages from faulty conditions & improper use. The protection indicatior will switch on due to short circuit connection & speaker overload, thus the amplifier will be turned off. Prior to inspecting the occurred problem, turn all levels down & all power off, then carefully check the installation for wiring mistakes, shorts or faulty ground (GND). - Page 10 Items not installed by authorized dealers will be warrantied for 30 days from the original purchase. Original sales receips must be accompanied with all returns.The warranty applies to the original purchaser of the product & it being sold by authorized B2 audio dealers.